detector output meaning in Chinese
检测器输出
Examples
- Its function is that the weak pulse of the detector outputs are carried on enlargement and reshaping
该放大器的作用是对探测器输出微弱脉冲进行放大、整形。 - Moreover because the detector output pulse signal base is very broad , its scope has a long tail , it can not adapt to request of the multichannel pulse amplitude analyzer
另外由于探测器输出脉冲信号底部较宽,脱尾严重,不能满足多道脉冲幅度分析器的要求。 - When the water mass fraction is set at 65 % , the ec detector indicates a power function relation between the detector output and the substrate ec , and the correlation factor of the proposed model reaches 0 . 970
控制基质质量含水率在65 %左右时,仪器输出与基质溶液电导率呈幂函数关系,所建立的模型的决定系数达到0 . 970 。 - The common detector output pulse signal scope is several dozens millivolts , but the multichannel pulse analyzer input pulse amplitude request is 1 - 15v , therefore the pulse linear amplifier must have the certain voltage gain , about ten times to several times
一般探测器输出脉冲信号幅度为几十毫伏,而多道脉冲幅度分析器输入脉冲幅度要求为1 - 10v ,所以脉冲线性放大器必须具有一定的电压放大增益,为数倍到上百倍。